SP command example

The SP command augments the LT command; it must be used to ensure that the LT command displays the correct TSR count value. Prior to Release 7.0.0, without first issuing the SP command, you may see an incorrect count. Since Release 7.0.0, this is no longer required. Figure 109 shows output for TSR Count incorrectly as 0. Figure 110 shows an SP command issued, resulting in a correct TSR count.

Figure 109. Batch output showing LT command results w/o SP command
Batch output showing LT command results w/o SP command

Figure 110. Batch output showing LT command results with SP command
Batch output showing LT command results with SP command